We defined the interfaces between the air/snow, snow/ice, and ice/ocean and calculated the ocean heat flux for two SIMBA recordings (SIMBA2015a and SIMBA_2015f) of repeated temperature profiles at 6h interval and 2cm vertical resolution, during N-ICE 2015 experiment floe1. The snow/ice interface is derived from the sharp contrast in the diffusivity proxy values between both media. The snow/ice interface does not change except for slush formation associated with flooding events. The air/snow interface is calculated using simultaneous information from the vertical gradient of the temperature and the standard deviation over 24, 48, and 72 h period. Snow accumulation of more than 10 centimeters happened at different time for the 2 SIMBA. The ice/ocean interface is estimated from temperature profiles alone since the winter sea-ice remains colder than the ocean. The ocean just below the ice is at or just above the freezing temperature (estimated from a near surface conductivity-temperature-depth (CTD) sensor see Koenig et al. [2016]). The method detects (1) the first sensor, downward of the snow/ice interface, with a temperature above the ocean freezing temperature and (2) the last sensor in the ice with a temperature below the mean ocean temperature by at least twice the ocean temperature standard deviation in that profile. The ice/ocean interface is then defined as half way between the last sensor in the ice and the first sensor in the ocean. Note it take 3-4 days for the deployment hole to refreeze. Then the ice thickness remains constant up to 20 February when floe1 breaks. Simba_2015f stops working and SIMBA_2015a features basal melt events corresponding to temperature changes in the ocean. The consistency of the 3 interfaces estimate is validated with the thermal diffusivity proxy and the vertical and temporal derivatives of temperature. The ocean heat flux is derived from the latent heat flux which is directly proportional to the change in time of the ice/ocean interface depth and the conductive heat flux in the lower portion of the ice estimated 6 cm above the ice/ocean interface. The ocean heat flux values for SIMBA_2015a and SIMBA2015f range from -50 to 350 W/m2, and -50 to 150 W/m2 respectively, while the basal melt events associated with ocean temperature increase stand out in SIMBA_2015a.   The SIMBA data are available through the Norwegian Polar Institute’s data center (https://data.npolar.no/dataset/6ed9a8ca-95b0-43be-bedf-8176bf56da80) and the method of interface detection is thoroughly described in Provost et al. (2017). Note that all time series have been smoothed with a 36-h running mean.   Provost, C., N. Sennechael, J. Miguet, P. Itkin, A. Rosel, Z. Koenig, N. Villacieros-Robineau, and M. A. Granskog (2017), Observations of flooding and snow-ice formation in a thinner Arctic sea-ice regime during the N-ICE2015 campaign: Influence of basal ice melt and storms, J. Geophys. Res. Oceans, 122, 7115–7134, doi:10.1002/2016JC012011. Important Note: This submission has been initially submitted to SEA scieNtific Open data Edition (SEANOE) publication service and received the recorded DOI. The metadata elements have been further processed (refined) in EMODnet Ingestion Service in order to conform with the Data Submission Service specifications.

Two ice mass balance instruments (part of IAOOS7 and IAOOS8 platforms) deployed near 83°N on the same ice floe, documented the evolution of snow and ice conditions in the Arctic Ocean north of Svalbard in Jan-Mar 2015. Frequent profiles of temperature (every 3 hours) and temperature change after 30s and 120s heating (once a day) were recorded. The ratio of the temperature changes after heating provides a proxy for thermal diffusivity. Both instruments documented flooding and snow-ice formation. Flooding was clearly detectable in the simultaneous changes in thermal diffusivity proxy, increased temperature, and heat propagation through the underlying ice. Slush then progressively transformed into snow-ice. Flooding resulted from two different processes; i) after storm-induced break-up of snow-loaded floes for IAOOS8 and ii) after loss of buoyancy due to basal ice melt for IAOOS7. The instrument on IAOOS7 documented basal sea-ice melt over warm Atlantic waters and ocean-to-ice heat flux peaked at up to 400 Wm-2 in winter. Important Note: This submission has been initially submitted to SEA scieNtific Open data Edition (SEANOE) publication service and received the recorded DOI. The metadata elements have been further processed (refined) in EMODnet Ingestion Service in order to conform with the Data Submission Service specifications.

Inorganic carbon and alkalinity measured during the (Amandes 1)-[https://doi.org/10.17600/7110080] cruises in October 2007. Important Note: This submission has been initially submitted to SEA scieNtific Open data Edition (SEANOE) publication service and received the recorded DOI. The metadata elements have been further processed (refined) in EMODnet Ingestion Service in order to conform with the Data Submission Service specifications.